Page 1: ...ocos The CRE 57091 PWM Linear DC filter is available to remove the PWM element N B Removing the PWM factor may result in slightly less smooth starting stopping for some locos INSTRUCTION MANUAL THESE INSTRUCTIONS REFER SPECIFICALLY TO THE TITAN TRACKSIDE HANDPIECE Only one channel is required for both speed and direction The Throttle Direction knob has a convenient centre OFF détente position with...
Page 2: ...once every 2 seconds Turn TX ON both knobs centred Within a couple of seconds the bind LED will go solid ON indicating the TX RX are already bound If the bind LED continues to flash slowly binding will be necessary BINDING is accomplished by following a few simple steps below AUTOMATIC BINDING 1 1 Turn the TITAN 3 base unit ON The RX in the case will blink slowly once every 2 seconds 1 2 After 20 ...
Page 3: ...again As soon as the Tx and Rx unit link together the Speed Control part will start flashing alternately Then press that button within 2 x seconds Be careful the case cover is replaced correctly See diagrams on Page 4 Then twist the Big Knob once in each direction to the end of knob travel and return to neutral This sets the default direction maximum speed in each direction If track has the wrong ...
Page 4: ......
