– 2 –
PREPARING THE
#EVO-BATT
THESE INSTRUCTIONS REFER TO THE
RCS EVO-BATT
2.4 GHz 3 CHANNEL R/C.
LAYOUT OF THE EVO-BATT TRANSMITTER HAND PIECE.
The combined reverser
– speed control knob is on the left.
Top left is the ON
– OFF switch with LED. Top right is the Bind/Ch # 5 pushbutton.
Two sound trigger functions are on the right.
1.
“BINDING”.
The 1st procedure is to “BIND” the receiver (Rx) to the Transmitter (Tx).
“BINDING” is accomplished by following a few simple steps below.
When binding we recommend removing any servos from the Rx in case they are not correctly adjusted. Adjust servo
parameters after binding has taken place.
HOW TO “BIND” USING A DSM2 Rx.
MANUAL BINDING using a binding plug.
1.1
I
nsert the “BINDING” plug supplied with the DSM2 Rx into the “BINDING” pins on the
Rx
.
You can also use the # BINDER switch assembly if you do not wish to get inside the loco.
1.2.
The Rx LED will start blinking very rapidly to indicate it is ready to be bound.
ON OFF SWITCH
PRESS & HOLD BIND THEN TURN ON.
1.3
Press
and hold
the right pushbutton on the handpiece marked with a hexagonal symbol. You may need to keep Tx
& Rx about 1 x metre apart for binding to take place.
1.4
Then press
and hold
the ON
– OFF button to
ON
. Hold both buttons until the Rx LED stops flickering & starts
blinking slowly. Then let both Tx buttons go. The Tx button also blinks slowly & then goes to solid ON.
1.5
The LED on all Rx
’s will blink more slowly & then go solid ON when “BINDING” is complete.
N.B.
“BINDING” plug
MUST
be removed
BEFORE
the SYSTEM is turned OFF.
1.6
T
he “BINDING” plug is removed & stored safely.
RCS offers an optional extra
# BINDER
cable and switch. When fitted this will enable any non RCS loco to be bound to
any Tx without requiring access to the inside of the loco. This will enable any loco to be swapped between any other
DSM2 Tx
’s. You will be able to “hand off” speed matched locos for MU’ing into a consist.
If the manual bind Rx has been replaced with an Auto Bind Rx, refer to the Auto Bind Rx instructions for how to use.
If the manual bind Rx has been replaced with an Auto Bind Rx, refer to the Auto
Bind Rx instructions for how to bind and wire in.
Summary of Contents for EVO-BATT
Page 4: ......
