2
** If you have a frequency counter, you can remove jumper 2 and then adjust the
frequency by frequency counter as well. Be sure to set back jumper for next
procedure.
2). Place the two remotes within 2 cm of each other. Press and hold the button of
existing remote that you want to copy from and press and hold the button of
REMOCON remote that you want to copy to and wait until the LED of Remocon
remote flashes 3 times. Repeat above step for the rest buttons you wish to copy.
3). When you finish it, remove jumper 2 and place it in a way that only one leg is
connected. (This can prevent from losing your jumper next time you want to
program the remote.)
4). Please make sure only to program remotes in areas far from
electrical interference. Otherwise, the remote may program incorrectly.
P.S. If you did not know the existing remote is hopping or not, suggest to do step 2
first. Just need to test one button of it and see whether LED of REMOCON
remote flash 3 times. Do this to make sure that existing remote is OK to be
copied. The procedures must be done in order from step 1 to step 3.
