12
REMKO ETF 320
The units are equipped with four
foot rollers and an additional
handle for easy and convenient
transport.
■
Before each change of location,
switch off the unit and remove
the power plug from the mains
socket
■
Empty the condensate
container completely
■
If moisture residual remains on
the evaporator or water remains
in the condensate container, the
units must only be transported
in an upright position
■
The transport rollers are only
suitable for use on level and
smooth ground
■
The devices must be carried
when transporting on rough
terrain or uneven surfaces
All moving parts have
a low-maintenance permanent
coat of lubricant. The entire
refrigerant system is designed as
a maintenance-free, hermetically
sealed system and may only be
repaired by a specialist.
■
Observe the regular care and
maintenance intervals
■
In accordance with the
operating conditions, the units
must, if necessary, be checked
at least yearly by a specialist
to ensure that they are in
a condition that is safe to use
■
Only clean the units with a dry
or damp cloth
Do not use a water jet!
■
Never use abrasive or
solvent-based cleaners
■
Use only suitable cleaners, even
for heavy contamination
■
Check the inlet and outlet grille
for contamination on a regular
basis
Clean or replace if required!
Care and maintenance
NOTE
Regular care and maintenance
is fundamental to a long
service life and fault-free
operation of the unit.
NOTE
Beware of dripping
condensate.
After switching off the units,
the evaporator may continue
to defrost under the influence
of the ambient temperature.
Cleaning the condenser and
evaporator
The unit housing must be opened
to allow the inside of the unit to be
cleaned and to provide access to
electrical components.
■
Clean the condenser and
the evaporator by blowing,
vacuuming or using a soft brush
Do not use water jets!
■
Clean the interior surfaces
on the units, the condensate
traps with hose connection,
the fan and the fan housing
carefully
■
Check all unit components for
damage and repair if necessary
■
Carefully refit all parts that
were removed in reverse order
NOTE
When cleaning the exchanger,
particular care must be taken
because the fine aluminium
fins bend very easily.
NOTE
Adjustment and maintenance
work may only be carried out
by authorised and qualified
technicians.
Unit transport
Before undertaking any work
on the units, the power plug
must be removed from the
mains socket.
!
CAUTION
The mains cable must never
be used as a pull cord or fixing
device.
!
CAUTION
An electrical safety check must
be carried out in accordance
with VDE 0701 after any work
on the units.
!
CAUTION
