5
NOTE:
The Adjustable Beard Comb has 8 length settings (1-8mm) and is designed for use on
the beard. The Adjustable Hair Clipper Comb has a further 8 length settings (9-16mm) and may
be used on long beards or on the hair on your head.
Begin with a higher numbered setting. Adjust cutting length as desired once you are familiar
with using the groomer, it is better to select a longer hair length setting in order not to trim too
much hair.
NOTE:
The foil shaver is designed to shave the detailed areas around your beard, moustache
and sideburns. It is
not
designed to shave your entire face.
TIPS FOR BEST RESULTS
• Beard, moustache and sideburn hairs should be dry.
• Avoid using lotions before using your groomer.
• Comb your hair in the direction that it grows.
• Remove the Adjustable Beard Comb attachment if you are: defining hairline edges such as
sideburns, trimming the nape of your neck, trimming your beard line on front of neck.
• Before trimming beards, comb your hair in the direction that it grows so that the hairs are at
their maximum height and facing in the same direction.
• Since all hairs do not grow in the same direction, you may want to try different trimming
methods (i.e. upwards, downwards or across). Practice is best for optimum results.
• Use slow light pressure. Too much pressure may trim off more hair than desired.
BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the battery.
• Ensure the trimmer is discharged of all power.
• Firstly, pry the detail blade head housing using a single-side screwdriver.
• Using a small screwdriver, unscrew 2 screws on the back housing of the trimmer.
• Continuously pry the front housing using the single-side screwdriver.
• Pry the PCB holder assembly again using the single-side screwdriver from the back housing
so you can see the PCB and batteries exposed.
• Destroy the PCB holder using a wire cutter, cut the tabs on both ends of the battery assem-
bly and remove the PCB.
• Dispose of the batteries safely
