ENGLISH
2
SAFETY CAUTIONS
WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION OF A
RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL OPERATING
CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN ELECTRICIAN FOR
ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM,
IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR OTHER
VESSELS CONTAINING WATER OR OTHER LIQUIDS.
This product is not suitable for use in bath or shower.
THE STYLER SHOULD BE UNPLUGGED FROM MAINS SUPPLY WHEN NOT IN
USE.
Do not leave the styler unattended when switched on.
Allow the styler to cool down before storage.
Do not immerse in water or other liquids.
Do not place styler on soft material e.g. carpet, bedding, towels, rugs etc.
Always ensure the voltage to be used corresponds to the voltage stated on the unit.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge can
give cause to hazards. Persons responsible for their safety should give explicit instructions
or supervise the use of the appliance.
Do not use any attachments with this styler, other than those supplied by Remington
®
.
Avoid allowing any part of the hot plates to contact the face, neck or scalp.
Do not wrap the cord around the unit. Check cord regularly for any sign of damage.
This product is not intended for commercial or salon use.
Damaged cords can be dangerous. If the supply cord of this unit becomes damaged,
discontinue use immediately and contact the Remington
®
help desk for repair or
replacement in order to avoid a hazard.
Special tools are required for any examination, adjustment or repair. Unqualified repair
work could lead to hazardous conditions for the user.
We do not accept responsibility for damage to the product, persons or other items(s),
caused by misuse, abuse or non-compliance with these instructions.
WIRING INSTRUCTIONS UK Plugs Only
This product is fitted with a BS1363 plug fused at 13A. If the plug is unsuitable, it should be
disconnected and an appropriate plug fitted as detailed below. If it is necessary to replace
the plug fuse, use only fuses that are approved to BS1362, rated at 13A. If in doubt consult a
qualified electrician.
100587_REM_IFU_S2880ZBA_21L.indd GB_2
100587_REM_IFU_S2880ZBA_21L.indd GB_2
11.08.10 20:50
11.08.10 20:50
