![background image](http://html1.mh-extra.com/html/remington/rm4040/rm4040_operating-manual_1437141014.webp)
14
WALL-MOUNTING THE CHARGER (OPTIONAL)
The battery charger can be mounted to a permanent surface, such
as a wall or work bench. Use mounting fasteners (not included)
capable of supporting the combined weight of the battery and
battery charger. Wall-mounting holes are located on the bottom of
the charger (Fig. 10).
Fig. 10
Wall-Mounting
Holes
CHARGING THE BATTERY
NOTE:
The battery is not shipped fully charged.
NOTE:
Lithium-ion batteries will not develop a memory and may be
charged at any time.
For maximum run time, fully charge the battery before each use.
1. Plug the battery charger into an appropriate power outlet. The
LED should turn red (constant) (Fig. 12). If it does not:
• Make sure the battery charger is fully plugged into an
appropriate power outlet.
• Make sure the power outlet is functioning by testing it with
another electrical device.
2. Insert the battery into the charging dock (Fig. 11). Push the
battery firmly until it locks into place.
3. Examine the LED. The LED will indicate the battery status:
•
Green (blinking):
The battery is charging. Charge the battery
until the green light stops blinking.
•
Green (constant):
The battery is fully charged.
•
Red (blinking - slow):
The battery and/or charger are too hot
or too cold. Make sure the battery and charger are in an
environment between 32° and 104° F (0° and 40° C). Allow
time for the battery and/or charger to warm up or cool down.
•
Red (blinking - fast):
The battery is no longer functional. Refer
to the
Warranty
section for replacement information.
•
Red (constant):
The battery is not charging. Remove the
battery. Make sure the terminals on the battery and battery
charger are clean. Re-insert the battery into the charging dock.
Push the battery firmly until it locks into place.
4. To maximize the life of the battery, the battery charger will turn
off when charging is complete. Once the battery is fully charged,
remove it from the battery charger. Optionally, the battery can be
stored in the battery charger, but the battery charger should be
unplugged from the power outlet.
To remove the battery: Hold the battery charger in place with
one hand. Press the battery release button with the other hand
(Fig. 13). Slide the battery out of the charging dock.
Fig. 11
Battery
Charging Dock
Fig. 12
LED
Fig. 13
Battery Release
Button
Summary of Contents for RM4040
Page 96: ......