NEVER LEAVE HEATER UNATTENDED WHILE
CONNECTED TO A POWER SOURCE
© 2013, Pinnacle Products International, Inc.
Garage Heater User’s Manual
Operation
Operation
1.
Position the fan heater so that it stands
upright on a firm, level surface and at a
safe distance from wet environments and
flammable objects.
2.
Connect the fan heater to the proper electrical
power. See Grounding instructions
(Page 8 and Figure 2)
3.
Set the thermostat dial to the maximum
temperature.
4.
The fan heater will switch on when the
function selector dial is set to one of the three
power settings.
5.
Once the room reaches the desired
temperature, turn the thermostat dial back
until heating element turns off.
Automatic Overheat Safety Control
–
This heater is equipped with safety internal
heat limiting thermostat and overheat
protection circuit. When a potential overheat
temperature is reached, the system will
automatically shut the heater off
Thermostat Instructions
–
At first, set the thermostat to “+” and let the
heater operate with full power input. When
the room temperature reaches the required
value, turn the thermostat to the left until it
switches off.
–
The thermostat will then switch on and off
automatically to control the room temperature
according to the preset value and keep the
room temperature constant.
–
When using the heater for the first time, you
may notice a slight emission of smoke. This
is quite normal and it stops after a short
time. The heating element is made of steel
and was coated with a layer of protective oil
during production. The smoke is caused by
the leftover oil as it is heated.
Setting
Function
Unit is Off
Fan Runs - No heating
Fan Runs - Half Power Heating
Fan Runs - Full Power Heating
NOTE
: The fan will run continuously while the
heater is operating.
7
