Remington PG9100, Manual

Page: 8 / 176

8
• Insert a flat bladed screwdriver between the sides of the foil screen and the head
assembly and pull away from the notches.
• To reassemble, slide the foil into the shaving head and click into position. Hold the foil
by the plastic frame to prevent damage.
REPLACING THE CUTTERS
• Remove the shaving head assembly by pressing the buttons on both sides of the
shaver.
• Grasp the cutter between your thumb and forefinger and pull upwards.
• Snap the new cutter into the oscillator tip.
• Note: DO NOT press on the cutter ends as this may cause damage.
BATTERY REMOVAL
We strongly recommend that a professional removes the rechargeable battery. Parts of
the shaver case, and tools have sharp edges and may cause injury if not handled correctly.
• The rechargeable battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.
1. Ensure the device is discharged of all power. To do this, switch it on and allow it to run
until it stops.
2. Remove the T-blade.
3. Pry and remove the top decorative panel and top housing.
4. Unscrew the 2 screws on the inner housing, and take off the top inner housing.
5. Take out the assembly of battery and printed circuit board.
6. Disconnect he battery from the circuit board.
• Used batteries must be removed from the appliance and disposed of at an appropriate
official recycling/collection point.
RECYCLING
W
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate official recycling/
collection point.
ENGLISH