Remington MB4128, Manual

Page: 6 / 12

6
Comb Position Cutting Length
5 9mm
6 11mm
7 13mm
8 15mm
9 18mm
• Note: Use the beard trimmer without the adjustable comb for trimming hair close to
the skin. This will trim hair to 1mm, holding the blades perpendicular to the skin will
trim hair to 0.4mm.
ATTACHING AND REMOVING THE ADJUSTABLE COMB
• Ensure the trimmer is switched off.
• To attach the comb place the comb on the beard trimmer so that the teeth of the
comb sit on top of the teeth of the blades.
• Slide on the comb until it sits securely on the beard trimmer.
• To remove the adjustable comb, ensure the trimmer is switched off.
• Push the back of the comb upwards and lift away from the beard trimmer.
• Note: the on/off switch controls the adjustable comb lock switch to ensure
consistent grooming results. When the trimmer is turned on the comb lock switch is
enabled. When the trimmer is turned off the comb lock switch is disabled. This is
when the comb length is able to be adjusted.
TO THIN AND TAPER THE BEARD/MOUSTACHE
1. Attach the adjustable comb to the trimmer blade and select the desired length by
sliding the adjustable comb up or down.
2. The setting will appear on the length position indicator on the comb. If you are
trimming for the first time, start with the maximum trimming length setting.
3. Once you have your desired adjustable comb length turn the trimmer on, this will
secure the length increment on the comb.
4. Place the flat top of the trimmer comb against the skin.
5. Slowly slide through the hair. Repeat from different directions as necessary.
TRIMMING THE NAPE OF YOUR NECK
Note: you will need a hand mirror for this operation if performing it alone.
1. Remove the adjustable comb.
2. Use your fingers to lift the hair at the base of your head up off the neck. Your index
finger should be covering the roots of the hairs you are lifting to prevent accidental
removal by the beard trimmer.