Remington i-Light, Manual

Page: 15 / 156

15
ENGLISH
,
The treated areas become red after treatment.
• This is normal and the redness should subside. If not, try using a lower energy level.
,
BE AWARE: If the unit is used over an extended period of time, the unit might automatically disable
momentarily (estimated 40 seconds) to cool down. Once the unit has cooled down, it will be ready to
use again.
LED’s
All currently selected energy level
indicators flashing.
Unit is overheated and is disabled
momentarily to cool down.
All energy level indicators flashing. Unit is malfunctioning. Turn the unit off,
wait a few moments and try again. If
problem persists, the unit should be
returned for repair.
All LED’s flashing with warning beep. Treatment head is removed or loose.
SOUNDS
Not full contact. Flash button was pressed while the skin
contact sensor was not fully engaged.
Replace bulb. Bulb is missing or needs to be replaced.
Skin contact sensors stuck. Flash button was pressed after the skin
contact sensor had been engaged since
unit start up. Skin contact sensor may be
stuck.
GB
D
NL
F
E
I
DK
S
FIN
P
SK