11
10
✹
Bulb Status Indicator Display (fig. 1-8)
The device is ready to flash when the Bulb Status Indicator Display is illuminated green.
NOTE:
if the Flash Button is pressed AND the Skin Contact Sensor is not fully engaged OR the
Bulb Status Indicator Display is not illuminated, an audible “beep” will sound.
been used up and will no longer operate. You must replace the bulb cartridge to continue
using the device.
✹
Treatment Head Release Buttons (fig. 1-14)
Press both buttons and gently pull to remove the treatment head.
✹
WARNING:
ALWAYS ensure the unit is OFF and the power cord is disconnected before
removing the nose cone. If the nose cone is removed while the unit is powered ON, all
GETTING ACQUAINTED WITH YOUR i-LIGHT DEVICE
✹
Long-Life Light Cartridge (fig. 1-15)
While it is unlikely you will ever need to replace it; it can be replaced by another long-life
car
Remington
™
Service Centre.
✹
Energy Level Selection (fig. 1-6)
The i-Light device is equipped with 5 energy levels. Level 1 is the lowest setting and level 5 is
the highest setting.
TIP:
discomfort on the skin. To determine the energy level being used, observe the number of
lights illuminated on the Energy Level Display (fig 1 - 9).
Your i-Light device will automatically be set to Energy Level 1 each time the device is powered
ON. To change the level, press the Energy Level Selection Button.
✹
Test the i-Light device on your skin
1. Review the Warnings and Safety Precautions.
2. Familiarise yourself with the features of the i-Light device.
3. Consult the Skin Tone Chart to ensure your skin colour is in the acceptable range. (fig. 5)
4. Place the skin of the intended treatment area onto the skin tone
sensor - touching the skin tone sensor (fig. 6)
If your skin is suitable, the appliance will beep and switch on.
5. Test the i-Light device on a small patch of skin and wait 48 hours to ensure there are no
adverse reactions. (fig.7)
Fig 5
Fig 6
Fig 7
✹
Treat desired area(s) with the i-Light device
Prepare your skin for treatment
1. Ensure the area to be treated is clean and free from oils, deodorants, perfume, make up,
lotions and creams. Shave or trim the hair from the area to be treated. (fig 8)
2. Never use wax, epilation, tweezers or depilation products to remove the hair because
they counteract the IPL process.
™