![background image](http://html.mh-extra.com/html/remington/f3-style-series/f3-style-series_manual_1437226006.webp)
6
REPLACING THE CUTTERS
•
Grasp the cutter between your thumb and forefinger and pull upwards.
•
Snap the new cutter into the oscillator tip.
•
Note: DO NOT press on the cutter ends as this may cause damage.
BATTERY REMOVAL
•
The battery must be removed from the appliance before it is scrapped.
•
The appliance must be disconnected from the supply mains when removing
the battery.
1. Turn the shaver on and discharge all remaining power.
2. Open the pop-up trimmer.
3. Use a screw driver to remove the 2 screws under the trimmer.
4. Unscrew the single screw on the back of the shaver.
5. Using a flat screw driver, carefully pry off the side decorative panel.
6. Pry apart the front and rear parts of the shaver body.
7. Take out the battery and printed circuit board assembly.
8. Disconnect the battery from the circuit board.
9. Dispose of the battery safely.
RECYCLING
W
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate official recycling/
collection point.
Summary of Contents for F3 Style Series
Page 2: ...e f l j l A B g i k C ...