Remington EP7 Series, Instructions Manual

Page: 9 / 12

9
3. Remove the blade and trimmer assembly by placing your fingers either side of the
assembly and pulling upwards.
4. Gently shake the blade and trimmer assembly to remove the hair. Use the cleaning
brush to brush the trimmers and shaver housing.
5. Replace the blade and trimmer assembly.
NOTE : Never use the cleaning brush on the foil as damage may occur.
CLEANING THE PEDICURE HEAD AFTER EACH USE:
1. Ensure the epilator is turned off and disconnected from the mains.
2. Press the head release button and remove the pedicure head.
3. To clean, gently brush the roller head with the cleaning brush.
• Note: the Pedicure Head is not washable.
CLEANING THE EXFOLIATING BRUSH HEAD AFTER USE:
• Ensure the epilator is turned off and disconnected from the mains.
• Press the head release button and remove the exfoliating brush head.
• To clean, rinse bristles under water and allow to dry.
BATTERY REMOVAL
• Battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the
battery.
1. Turn the unit on and discharge all remaining power.
2. Begin by removing the head attachment from the unit.
3. Using a small screw driver remove the screw at the bottom of the unit.
4. Unclip the decorative panel from the unit.
5. Pull and slide out the inner housing to reveal the PCB and battery.
6. Cut the wires on both ends of the battery. Remove the battery.
7. Battery is to be disposed of safely.
RECYCLING
W
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate official recycling/
collection point.