![background image](http://html1.mh-extra.com/html/remington/cld3516awb/cld3516awb_owners-manual_1437105015.webp)
ENGLISH
17
www.desatech.com
Guide Bar With
Uneven Wear
Guide Bar
Normal Guide
Bar
Guide Bar Groove
E-Ring
Sprocket Support
Guide Bar Bolts
Guide Bar
Flat File
Burr
Oil Slot
Cleaning Groove With Putty
Knife
Guide Bar
CARE OF GUIDE BAR
Uneven bar wear causes most guide bar problems.
Incorrect sharpening of chain cutter and depth gauge
settings often cause this. When bar wears unevenly,
it widens guide bar groove (see Figure 19). This
causes chain clatter and rivet popping. Saw will not
cut straight. Replace guide bar if this occurs.
Inspect guide bar before sharpening chain. A worn or
damaged guide bar is unsafe. A worn or damaged guide
bar will damage chain. It will also make cutting harder.
CLEANING SAW BODY
WARNING: When cleaning saw
body,
• do not submerge saw in any liquids
• do not use products that contain am-
monia, chlorine, or abrasives
• do not use chlorinated cleaning sol-
vents, carbon tetrachloride, kerosene,
or gasoline
Keep saw body clean. Use a soft cloth dampened with a
mild soap and water mixture. Wipe saw body to clean.
Normal Guide Bar Maintenance
1. Remove sprocket cover (see
Clearing Sprocket
Cover of Debris,
page 14).
2. Remove
saw
chain.
3. Remove E-ring and sprocket support (see Figure
20).
4. Remove
guide
bar.
5. Remove sawdust from guide bar groove periodi-
cally. Use putty knife or wire (see Figure 21).
6. Clean oil slots after each day of use.
7. Remove burrs from sides of guide bar. Use flat
file to make side edges square.
Replace guide bar when
• bar is bent or cracked
• inside groove of bar is badly worn
Note:
When replacing guide bar, see
Replacement
Parts and Accessories,
page 19, for proper bar.
Figure 19 - Guide Bar Cross Section Showing
Uneven Bar Wear
Figure 21 - Guide Bar Maintenance
CLEANING AND
MAINTENANCE
WARNING: Cutting edges on chain
are sharp. Use protective gloves when
handling chain.
IMPORTANT: Do not clamp chain saw in
vise during assembly.
Figure 20 - Removing E-Ring and Sprocket
Support
For parts contact: www.PartsFor.com