4
•
Do not twist or kink the cable, or wrap it round the appliance. Check the cord
regularly for any sign damage.
•
This appliance is not intended for commercial or salon use.
PARTS
1. 1000W power handle
2. Speed/heat selector switch (
f
,
N
,
O
)
3. 50 mm mixed bristle brush
4. 38 mm retractable brush
5. Bristle retraction control
6. Paddle brush
7. Pre-styling nozzle
8. Removable inlet grille
9. Hang up loop
10. Swivel cord
INSTRUCTIONS FOR USE
Prepare the hair for styling
•
Wash and condition the hair as normal.
•
Squeeze out excess moisture with a towel and comb through.
•
Using the pre-styling nozzle rough dry the length and roots until 80% dry.
•
Divide the hair into sections, style the lower layers first.
To fit/remove attachments
Fit the attachment before you turn on the appliance.
CAUTION: Attachments can become hot during use, let them cool before removing.
1. To remove, twist the attachment until the markings line up as shown in figure A and
pull it off the power handle.
2. To fit an attachment, align the symbols on the power handle and attachment as
shown in figure B then twist the attachment until it locks into place.
Speed and temperature settings
1. Plug your styler in to the mains power supply.
2. Turn your air styler on and select the appropriate setting for your hair by sliding the
speed/heat selector switch.
3. Your air styler has three settings:
•
High heat/speed (
O
): Thick and difficult to style hair.
•
Low heat/speed (
N
): Thin/fine, damaged or bleached hair.
•
Cool (
f
): Helps to set your style with cool air.
Create volume using the 50 mm brush
•
To dry your roots and add volume, place the brush underneath the section close to
the roots and hold for a few seconds, lifting the hair as you dry.
•
Move the styler downward through the hair section.
•
Repeat this around the head.
•
Let the hair cool before further styling.