![background image](http://html1.mh-extra.com/html/remington/18-volt-cordless-bs188a/18-volt-cordless-bs188a_owners-manual_1437101011.webp)
www.desatech.com
ww.desatech.com
11
EN
G
LIS
H
www.desatech.com
ww.desatech.com
CHAIN SAw INFORMATION
ChAin SAW ASSembLy
1. Align rib on chain saw power head with
groove in main handle (see Figure 5).
2. Slide power head into main handle until
units “snap” together (see Figure 6).
Important:
Both release buttons on
main handle must be fully engaged.
3. Slide battery onto main handle until
release buttons “snap” together (see
Figure 7).
note:
Fully charge battery before using
for first time. See
Charging Battery
,
page 10.
wARNING: Cutting edges on
chain are sharp. Use protective
gloves when handling chain.
Figure 6 - Assembled Power Head
Main Handle
note:
The saw chain tension is properly set at
the factory. A new chain will stretch. Check
new chain tension frequently (after discon-
necting battery) during the first 2 hours of
operation. Allow chain to cool down. Follow
steps below to check saw chain tension.
1. Remove battery from chain saw.
2. Place chain saw on a firm surface to
check chain tension.
SAw CHAIN TENSION
wARNING: Remove battery from
chain saw before adjusting saw chain
tension. Severe injury or death
could occur from body contact with
moving chain.
wARNING: Cutting edges on
chain are sharp. Use protective
gloves when handling chain.
wARNING: Maintain proper
chain tension always. A loose chain
will increase the risk of kickback. A
loose chain may jump out of guide
bar groove. This may injure op-
erator and damage chain. A loose
chain will cause chain, guide bar,
and sprocket to wear rapidly.
Main
Handle
Power Head
Rib
Groove
Figure 5 - Align Power Head with
Handle
Main Handle
Battery
Figure 7 - Assemble Battery
onto Main
Handle
NOTE:
Your Remington Cordless Polesaw
and Cordless Chainsaw may have been
purchased together (as a 2-in-1 polesaw/
chainsaw) or seperate (chainsaw only). If
the chainsaw was purchased separately, the
pole is available as an accessory and may be
purchased by visiting the "On-Line Outlet"
at www.desatech.com.
Figure 8 -
Check Chain Tension
3. Pull chain with light force 1/8" away
from bottom of guide bar and release
(see Figure 8). If chain lightly snaps
back into place, tension is correct.
A slight sag (1/16" or less) between
chain and bottom of guide bar is
acceptable.
Saw Chain Tension Adjustment
1. Loosen guide bar nuts before adjust-
ing chain (see Figure 9).
Guide Bar Nuts
Figure 9 - Loosen Guide Bar Nuts
2. Turn adjusting screw on front of
power head clockwise until slack is
out of chain (see Figure 10).
3. Wearing protective gloves, pull down
on chain to check chain tension (See
Step 3
Saw Chain Tension
).
Adjusting
Screw
Figure 10 - Turning Adjusting Screw
Summary of Contents for 18 Volt Cordless BS188A
Page 46: ...121071 01 REV A 11 07 ...