2 |
P a g e
3.
NOTE: using Remington Solar attic fans with ridge vents are fine. We recommend
putting your fan 5 feet down from your ridge vent. Also, close any vent within 8-10 feet of
your solar fan. (Cardboard underneath is an easy solution)
4. Before you begin, gently clean any oil residue from flashing.
5. Use a high quality silicone sealant to ensure a good waterproof seal
INSTALLATION
Step1
Choose a location for your Remington Solar Attic Fan on the south of the roof, considering
potential problems like tree, chimney etc. They may shade the solar panel during certain
times of the day, reducing run time.
If a southern or western exposure is not possible, the fan can be installed on any other
exposure and the solar panel can be adjusted to capture maximum sunlight. Note: The Solar
Attic Fan must be installed between roof rafters. However, if you want to retrofit an existing
turbine (Whirlybird) or electric fan, you may do so. Just enlarge the hole if necessary, being
careful not to cut through a rafter.
Step 2
Using either a string or template, create a 14 1/2 inch diameter circle onto the roof
shingles.
Note: Roof rafters are generally 16” or 24” on center. (Stick a nail from underneath out to
the roof, then find the nail, so you can see the center.)
Step 3
The Solar Attic Fan must be installed between roof rafters. Do not cut through any framing
member. With a reciprocating saw, cut the diameter of the hole.
Step 4
Remove any roofing nails in the area where the base will be slid under the shingles.
Step 5
Lay a bead of Silicone Sealant around the base of the flashing.
Step 6
Slide the flashing underneath the tar paper and shingles. Adjust the flashing up until the
shingles come into contact with the raised portion of the flashing. The bottom side of the
flashing will be on top of the shingles.
