REMEHA Gas 120 ACE - 115, User Manual

Page: 60 / 96

Parameter Text display Description Factory
setting
AP074 Force summer mode The heating is stopped. Hot water is maintained. Force Summer Mode
Adjustment range:
0 =Off
1 =On
0
AP079 Building Inertia Inertia of the building used for heat up speed
Adjustment range:
from 0 to 10
3
AP080 Frost min out temp Outside temperature below which the antifreeze protection is activated
Adjustment range:
from -30 °C to 20 °C
-10
AP091 Outside Sens. Source Type of outside sensor connection to be used
Adjustment range:
0 =Auto
1 =Wired sensor
2 =Wireless sensor
3 =Internet measured
4 =None
0
AP077 Max. display level Maximum Level of parameters and signals to display on MK
Adjustment range:
1 =End user
2 =Installer
3 =Installer advanced
4 =Lab
5 =Controls Development
2
9.11 Reading out measured values
9.11.1 Control unit counters
Tab.39 Navigation for basic installer level
Level Menu path
Basic installer
> Installation Setup > CU-GH08 > Submenu
(1)
> Parameters, counters, signals > Counters
(1) See the column "Submenu" in the following table for the correct navigation. The counters are grouped in specific functionalities.
Tab.40 Counters at basic installer level
Code Display text Description Range Submenu
AC005 CH Energy
Consumed
Energy consumed for central
heating
0 kWh - 4294967294
kWh
Gas fired appliance
AC006 DHW Energy
Consumed
Energy consumed for domestic
hot water
0 kWh - 4294967294
kWh
Gas fired appliance
Tab.41 Navigation for installer level
Level Menu path
Installer
> Installation Setup > CU-GH08 > Submenu
(1)
> Parameters, counters, signals > Counters
(1) See the column "Submenu" in the following table for the correct navigation. The counters are grouped in specific functionalities.
9 Settings
60 MID _HMI T-control - Gas 120 ACE 7717201 - v03 - 25062019