Important Note
The upper limit and lower limit of the screen had been preset in factory. Any adjustment to these 2 limit
switches may cause damages to the screen fabric. If adjusted, it will cause the following problems:
a) The screen will roll into the frame and stop by force and not by the Upper Limit switch.
This will cause overheating of motor which unable the screen to operate properly.
b) The depression of the bottom bar onto the fabric will cause horizontal mark on screen surface.
c) Adjusting the Lower Limit of the screen any lower than beyond the STOP sticker may cause the fabric
to drop off
Disclaimer
Any adjustment to these 2 limit switches will void the warranty for the screen and Remaco will hold
no responsibility for any damages to it. Please consult us if it is necessary to do any adjustment to the
limit switch.
STEP 4
End
Pairing ESC+ with AVA-315 1-Ch
Learning Mode
Step1. Press and Hold Switch S1 for 4 seconds.
Step2. Release Switch S1 and motor step-move up/down, LED1 flash slowly.
Step3. Press UP button on the RF remote, motor step-move again and stop.
Step4. LED1 off and “Learning” is completed successfully.
* NOTE: Make sure RF remote control is set close to ESC+ not further 20cm.
**NOTE: If nothing is pressed within 20seconds, the learning mode will disable and back
to normal mode.
Delete Mode
Step1. Press and Hold Switch S1 until the LED1 flash fast.
Step2. Release Switch S1.
Step3. Press Switch S1 again within 7seconds.
Step4. LED1 off, “Delete” mode is completed successfully.
ESC+ compatible with AVA-315 1-Channel Radio Frequency Remote
OPTION-2
AVA-315
Radio Frequency Remote
E) To set screen to your desired “up” and “down” positions.
Bottom View
Lower Limit
Adjust “
-
” : screen roll away from frame
Adjust “
+
” : screen roll into the frame
Screen Frame
STOP
+
-
+
-
Red Knob
Upper Limit
White Knob
Allen Key (# 4mm) to set
limit switch knob
Upper Limit
Lower Limit
Adjust “
-
” : less screen drop
Adjust “
+
” : more screen drop