18
OPERATING PROCEDURE
The display will show
FILt
that corresponds to the digital filter allowed for
selection
By pressing
MODE
you enter the digital filter selection, then
By pressing
ZERO
you switch to/from
L no
and
L SI
where:
L no
standard filter
L SI
oversized filter.
By pressing
MODE
you enter the selection
Set with
ZERO
a filter value 1to 9
By pressing
MODE
you store the selected parameter and go back to the setting
selection session.
By pressing
TARE
you move to the next parameter.(2)
By pressing
ZERO
you go back to the weighing state
The display will show
Aut 0
which corresponds to automatic zero on power-on
By pressing
MODE
you enter the automatic zero selection, then
By pressing
ZERO
you switch to/from
A no
and
A SI
where:
A no
automatic zero inhibited
A SI
automatic zero enabled.
By pressing
MODE
you enter the selection
Set with
ZERO
and
TARE
a value of weight within which the automatic zero will
be made.
By pressing
MODE
you store the selected parameter and go back to the setting
selection menu.
By pressing
TARE
you move to the following parameter.(3)
By pressing
ZERO
you go back to the weighing session
The display will show
-ZEro-
which corresponds to the zero setting
When the dynamometer is discharged, press
MODE
to perform the zero-
setting and automatically leave the settings in order to perform a visual check
of the setting made.
Press
TARE
to move to the next parameter.(4)
OPERATING PROCEDURE
The display unit will show
SPEGn
which corresponds to timed switching-off
Press
MODE
to enter the switch-off selection, then
Set the switching off time with
ZERO
and
TARE
(minutes)
Press
MODE
to store the selected parameter and go back to the setting
selection.
Press
TARE
to move to the next parameter.(5)
Press
ZERO
to go back to the weighing state
The display will show
Funct
, which corresponds to the peak or hold function
selection
Press
MODE
to enter the function selection, then
Press
ZERO
to switch to/from
F no
,
PEAK e HOLd
where:
F no
No function enabled
PEAK
Peak measurement function enabled.
HOLd
Weight block function enabled.
Press
MODE
to store the selected parameter and go back to the setting
selection.
Press
TARE
to move to the following parameter.(6)
FILt
AUt 0
ZEro
SPEGn
Funct
ZERO
1
2
3
4
5
TARE
TARE
ZERO
MODE
MODE
MODE
ZERO
ZERO
TARE
ZERO
MODE
MODE
MODE
ZERO
TARE
ZERO
MODE
MODE
ZERO
TARE
ZERO
TARE
MODE
MODE
Summary of Contents for DSD05 Series
Page 20: ...20 www rema eu ...