Press to start / stop AC Output
Press to start / stop DC Output
DISCHARGING THE OUTLAW 1072S
DISCHARGE OPERATION
1. Set the AC and/or DC power switches to the on position and plug your devices into the appropriate
receptacle(s). Use the provided power strip if more that one AC outlet is required. The backlit LCD screen may
shut off to preserve power if there are no active external loads. To activate display, apply an external load.
CHARGE OPERATION
During standby, the indicator on the AC charger (included accessories) shows that LED1 is red and LED2 is green.
During charging the battery pack LED2 turns red.
When the battery pack is fully charged, LED1 turns red and LED2 turns green. Please promptly disconnect the
charge cable upon charge completion.
If the Power Station’s total output exceeds 1,150W for more than 10 seconds, the BMS will go into protection
mode by opening the circuit to prevent damage to the battery. To recover from protection mode, set the AC and
DC switches to the off position and unplug all devices. Then set the AC and DC switches to the on position and
plug devices back in. You may need to limit the number of devices used at the same time to prevent the power
station from going back into protection mode.
The Power Station does not turn off automatically. Turn off each output by pressing its power button when not in
use to preserve power. The edge of the buttons are illuminated by a blue ring when powered on.
Children should not operate the power station without adult supervision
Care MUST be taken with ring terminals of the quick plug (EC5) when connected to the power station. They are
a direct live connection to the battery even when the AC or DC power is off. The quick plug (EC5) terminates in
ring terminals but these may be replaced with the appropriate matching connector for any DC appliance with
current requirements greater than 10 amps but less than 30 amps.
