SETUP
1. Power down the device in which the remote button
will be installed. Power down the first InSight battery
in the string by tapping the power button once and
then depressing the button until both LEDs on the
battery show solid red (approx 6 seconds). Release
button and the rest of the batteries in the string will
also power off.
2. Begin by locating the remote button Cable Assembly.
Route the connecting end through the button mounting
destination hole, ending in the battery compartment.
Use zip ties to secure the cable assembly to vehicle to
reduce strain on connections.
3. Attach the red ring terminal to the positive battery post
and then the black ring terminal to the negative battery
post on the first InSight battery in the bank.
4. Insert the CANBUS plug attached to the remote
button cable assembly in the CANBUS IN port on the
first InSight battery in the bank.
5. Installation is complete. Test the function of the
remote button by depressing the remote button until
the InSight Batteries in the string power on (approx
five seconds). LED 1 on all batteries will flash green.
REMOTE BUTTON - MOUNTING DIMENSIONS
WIRING DIAGRAM
Second
Battery
in String
First
Battery
in String
Remote Button Cable Assembly
CanBus IN
CanBus Out
Questions?
Contact RELiON Technical Support at (855) 931-2466
©2021 RELiON Battery, LLC. All rights reserved. RELiON is not liable for damages that may result from any information provided in or omitted from this
publication, under any circumstances. RELiON reserves the right to make adjustments to this publication at any time, without notice or obligation.
Button Install - Digital - 0
5
.
2
5.21
M16 x 1.0 THREAD
16.5 mm
16 mm
18 mm
M16 x 1.0 THREAD
16.5 mm
16 mm
18 mm
