Reliable F3QR80 Series, Manual

Page: 15 / 15

Ordering Information
Specify:
1. Sprinkler: [Model F3QR80 Dry Pendent SIN RA6112]
[Model F3QR80 Dry Horizontal Sidewall SIN RA6132]
2. Escutcheon/Cover Plate: [None][Standard escutch-
eon][Model HB extended escutcheon][Model FP re-
cessed escutcheon][Model CCP cover plate – pen-
dent only]
3. Inlet Threads: [1” NPT][ISO7-1R1]
4. Inlet Fitting: [Long – Standard Inlet Fitting][Short “PL”
– Wet Pipe Systems only]
5. Sprinkler Temperature Rating: See Temperature Rat-
ings table
6. Sprinkler Finish: See Finishes Table
7. Escutcheon/Cover Plate Finish: See Finishes Table
8. Length: “A” Dimension (face of tee to face of ceiling
or wall) in ¼” (6 mm) increments – See Fig. 1 through
Fig. 7
Note:
The “A” dimension is based on a nominally gauged pipe
thread “make-up” of .600” (15mm) per ANSI B2.1 [approxi-
mately 7 ½ threads].
Installation Wrench
Model F3R Sprinkler Wrench (Standard and HB escutcheons)
Model XLO2 Sprinkler Wrench (FP Recessed and CCP
Concealed)
Installation Data
Sprinkler Model Escutcheon or Cover Plate Suggested Hole Diameter in Wall or Ceiling Installation Wrench
F3QR80 Dry
Standard Escutcheon 2-1/8” (54 mm)
F3R
HB Extended Escutcheon 2-1/2” (64 mm)
FP Recessed Escutcheon
2-1/2” (64 mm) XLO2
CCP Cover Plate (Pendent Only)
Maintenance
The Model F3QR80 Dry Sprinklers should be inspected
and the sprinkler system maintained in accordance with
NFPA 25. Do not remove the factory applied thermally sen-
sitive wax fillet between the bulb supporting cup and the
wrenching boss. Do not replace this wax with a substitute
substance.
An Alternate substance may interfere with proper operation
of the sprinkler. Do not clean sprinklers with soap and water,
ammonia or any other cleaning fluids. Remove dust by us-
ing a soft brush or gently vacuuming. Replace any sprin-
kler which has been painted (other than factory applied) or
damaged in any way. A stock of spare sprinklers should be
maintained to allow quick replacement of damaged or op-
erated sprinklers. Prior to installation, sprinklers should be
maintained in the original cartons and packaging until used
to minimize the potential for damage to sprinklers that would
cause improper operation or non-operation.
Reliable Automatic Sprinkler Co., Inc.
(800) 431-1588 Sales Offices
(800) 848-6051 Sales Fax
(914) 829-2042 Corporate Offices
www.reliablesprinkler.com Internet Address
Manufactured by
Recycled
Paper
Revision lines indicate updated or new data.
EG. Printed in U.S.A. 09/21 P/N 9999970501
The equipment presented in this bulletin is to be installed in accordance with the latest published Standards of the National Fire Protection Association, Factory
Mutual Research Corporation, or other similar organizations and also with the provisions of governmental codes or ordinances whenever applicable.
Products manufactured and distributed by Reliable have been protecting life and property for over 100 years.