Reliable Equipment REL-CS16, Operator'S Manual

Page: 9 / 24

9
PRE-OPERATION OF SAW
WARNING! DO NOT connect hoses or fittings to this chainsaw before completing all the
following instructions.
Before attempting to run or use the saw, check all connections, including hoses,
couplings, chain tension, cleanliness, and ensure that safety trigger is moving freely.
Wear all safety items required and make sure that the working area is clear of
obstructions and non essential personnel. Set the saw to Open or Closed-Center,
according to which system the power supply pump provides. It is important to know
which type of power system is supplying the saw so that the chainsaw can be properly
set. All these items are crucial to the safe operating procedure of the chainsaw.
Setting Spool Selector for Open Center/Closed Center System
Make sure hoses are disconnected from the chainsaw and inspect the following items:
Inspect the saw chain. The chain tension should be set per Fig. 3. If the tension is too
tight, the saw guide bar will wear excessively. If the tension is too loose, the chain could
jump the track. Follow the settings as described in Fig. 3.
Set the automatic oiler as described in Fig. 2. If set properly, a fine mist should show at
the tip of the chain. Too much fluid will drain the reservoir of oil. Follow the instructions on
page 12. Check the fluid level regularly for fluid loss.
Inspect the chain for damage. The saw will not function properly with a worn or damaged
chain. Look for bending, wear, or any damage to the chain assembly.
Damaged chain assemblies could cause pinching or kickback, resulting in serious
injury to the operator.
CAUTION
New saw chains require a break-in period. The chain tension will need to
be adjusted frequently as described on page 13.
FIGURE 1
Turn Selector with
wrench or screw driver
Open-Center Closed-Center