Pg. 38
Doc ID: 191-6206A
Doc Rev: 062818
2. With the pin still pushed past the locking collar, turn 90° to
remove the pin and spring.
3. Remove the remaining 2 pins and springs from the same side
of the EXP base.
4. Drop a new spring into the spring slot
on the base, then add the ¼ turn pin.
NOTE:
Lining up the slot in the pin with the
tab in the EXP will
align the pin in proper
position for locking the pin.
5. Push the turn pin in far enough to clear the locking collar, then
turn 90° and release the pin. The pin should sit almost flush
with the EXP base.
6. Flip the EXP friction disk over, and repeat on the other side
depending on engagement preference.
Pin
locking tab
Push past
locking collar
