61
10.
Troubleshooting
Assistance for problem solving. If you are in any doubt, contact your sales representative or customer
service.
10.1.
Pick-up and rotor are not working
✓
Pressure build-up due to the sun shining on the hydraulic system.
10.2.
Rotor does not lift
✓
Contact fault on the valves.
✓
Check contacts, use contact spray
✓
Turn the knurled screws out and in again. If necessary, repeat the procedure
10.3.
Belt does not travel
✓
Contact fault on the valves or connector damage.
✓
Check contacts on the valves
✓
Check power supply
✓
Check connector.
10.4.
Pick-up tines make a noise when idling
✓
Too much contact between the tines and scrapers.
✓
Check pick-up for bent tines.
✓
Check pick-up for trapped foreign objects.
✓
Remove foreign objects, straighten out tines.
10.5.
Pick-up or rotor are stiff / sluggish
✓
Jammed drive elements.
✓
Check if foreign objects are jammed somewhere.
✓
Check if the harvest forage has become entangled; if required, clean the pick-up and rotor
10.6.
Conveyor belt is running lopsided
✓
Conveyor belt is moving strongly to one side
✓
Check the condition of the conveyor belt edge for wear.
✓
Correct conveyor belt operation by adjusting the fine adjustment when the belt is running
slowly.
✓
Removal of the pick-up must be avoided under all circumstances. Perform a belt running
correction via the two rear bearings.
10.7.
Conveyor belt rollers build up dirt
✓
Readjust the cleaning strip (1)
10.8.
Gliding discs do not rotate smoothly
✓
Bearing damaged?
✓
Check for contamination in the area of the bearing.
