REITEL POLYCURE, Operating Instructions Manual

Page: 8 / 16

8
Operating Instructions
4.1 Commissioning
1. Connect the power supply with the mains plug located on the device. On the front side is
the main switch (1) for switching on the device. After finishing work, switch off the
appliance with the main switch (1).
2. Open the lid (5) by turning it upwards.
3. Place the materials you want to harden on the turntable (6).
4. Close the lid (5).
5. Select the desired wavelength using the frequency control (3).
4.2 Programming
1. After being switched on by the main switch (1), the display shows the last stored runtime.
Press the
„Prog“ button on the control panel (2) to start setting the time. By repeatedly
pressing button 1, you automatically jump to the next setting (1x = hours, 2x = minutes,
3x = seconds, 4x = confirm).
2. Use the (+) or (-) button to set the respective time higher or lower. By holding the keys,
the time can also be set in increments of ten.
3. After confirming the selected time, press the Start / Stop button (3). The turntable (6) now
automatically starts to turn and the high-power LEDs (7) start to light up.
4. By pressing the Start / Stop button again, you can interrupt or restart the curing process
at any time.
5. By pressing the Reset key the time can be reset to the origin during the stop phase.
6. Once the time is up, the device stops automatically and an audible signal sounds. The
time is automatically reset to the startup setting.