REITEL POLIRET CLASSIC, Operating Instructions Manual

Page: 10 / 20

10
Installation
The electrical equipment is delivered fully installed. The sealed plug can be connected
directly to the mains supply 230 V / 16 A. Regarding installation, please adhere to safety
notes in chapter 2.
Installation
Leave a minimum space of 20 cm for exhaust air outlet at the back of the device and leave
sufficient space above the equipment for filter replacement. Connect to the power supply.
Tool assembly
1. Attach the polishing spindles (5) and (13) tightly to the axle and fasten them with a hex
screw. Check that they fit correctly.
2. Attach the polishing tool to the spindles (5) and (13). Check that it fits correctly.
Right side: right-handed thread.
Left side: left-handed thread.
3. Detach the polishing spindles (5) and (13) from the axle by removing the Allen screw. If
necessary, use a pressure tool.
Operation
Sequence of operation
1. Fix the polishing tool, if necessary fill in polishing paste and/or pumice in the polishing
troughs or apply to the polishing tool.
2. Turn the power switch (9) on.
3. Turn the polishing motor on with the speed selector switch (3) (step 1 = 1500 rpm, step 2
= 3000 rpm).
4. Switch on the extraction with the extractor switch (11). Suction performance can be
increased by closing one of the extraction channels (2) or (7), to increase extraction
performance on the respectively other side.
5. Hold the object to be polished tight and slightly push it against the rotating polishing tool.
6. After finishing work, turn off polishing machine with the speed selector switch (3) and the
power switch (10).