REITEL DUSTY ZIRKON, Operating Instructions Manual

Page: 12 / 24

12
Operation
The equipment delivered is ready for immediate use. The sealed plug can be connected
directly to the mains supply 230 V/16 A. For installation please refer to safety notes in
chapter 2.
Installation
1. Ensure that the cleaner is switched off. Turn switch (7)
to position “0” (off).
2. Check if a suitable filter is inserted in the device.
3. Insert the power cord into a properly installed and fused socket with earthing contact.
Hose Installation
1. Connect the supplied extraction hose to the latch (3).
2. The hose diameter must match the hose diameter setting (11).
3. Check the extraction hose for a tight fit.
Filter Installation
1. Open the retaining clamps and remove the upper section of the vacuum cleaner
(s. p. 6
– detail 2).
2. Press the filter bag connection firmly on to the inlet fitting in the dirt tank
(s. p. 7
– detail 7).
3. Attach the upper section of the vacuum cleaner. Close the retaining clamps (3). Ensure
that the retaining clamps fit properly (s. p. 6
– detail 1).
Connection of power tools
Attention:
To comply with regulations, only approved dust producing tools should be connected. The
maximum power consumption of the connected electrical appliance is stated in „Trouble-
shooting“, chapter 5 and „Technical Data“. The operating instructions incl. safety
instructions for the connected tool have to be adhered to.
1. Connect the extraction unit to a power tool (s. p. 7
– detail 6):
a. The extraction must be switched off (7).
b. Switch off the power tool.
c. Attach the end of the supplied extraction hose to the extraction connection sleeve
on the power tool.
d. Insert the plug of the extraction into the device socket of the power tool and
connect it to the mains supply 230 V/16 A.