Commissioning
20 / 40
TARAtec 10.1
4.4.2
Connection with 4…20 mA signal output
M12 screwed plug
The sensor is provided with a 5-pin M12 screwed plug protected against
polarity reversal.
The connection pins are assigned as follows:
Fig. 8:
Connection pin assignment (5-pin)
1
(not assigned)
2
+U
3
-U
4
(not assigned)
5
(not assigned)
Connection with a 2-pole screwed terminal block
The sensor is provided with a 2-pole screwed terminal block.
Insert the sensor cable through the cable gland of the
hood.
Connect the cores to the terminals in the sensor electronics.
Screw the hood finger-tight into the sensor body until the
O-ring seal is made.
Tighten the cable gland so as to secure the cable.
