MWS_55_e.indb Page 60
Manual MWS 55 / MWS 88 / MWS 10 and Sensors 55
geändert am 26.10.2017 von DO
REINHARDT
System- und Messelectronic GmbH
Fax: 08196/7005 and 1414 email:
http://www.reinhardt-wetterstationen.de
!F<#13>
Input flags for controls, !Fx, 0 <= x <= 255:
Bit 24 ENET_ENABLE (Activates the Ethernet oprt)
Bit 23 USB_ENABLE (Activates the USB-port)
Bit 20-22 Reserved
Bit 19 BIGDATA (Allows manually changing of digital outputs (heating, fan, ...)
Bit 9-18 Reserved
Bit 8 - Reserved (DEBUG_OUTPUT)
Bit 7 - Device-address (DA) with <CR><LF> in front of each data string
Bit 6 - Reserved
Bit 5 - Activates the GPS input for connecting another RS232 device.
By disabling this bit the interface and it's level shifter component is switched off.
Bit 1-4 Reserved
!F+<Bit#><#13> ;
Set single bit
!F-<Bit#><#13> ;
Disable single bit
Example: !F-5 disables GPS-input
Switching on / off single sensors (List of all available sensor some pages later):
!KX,A0<#13> ;
Sensor with output number X is disabled
!KX,A1<#13> ;
Sensor with output number X is enabled
Attenuation for sensor X enable / disable:
!KX,A1,1,1<#13> ;
Sensor with output number X is not averaged
!KX,A1,2,2<#13> ;
Sensor with output number X is averaged
!KX,MW1<#13> ;
Sensor with output number X is strongly averaged
!KX,M0<#13> ;
Average off for sensor X
Sending linearization data:
!L<SENSORNUMBER>,<INDEX : 1..8>,F<RAW VALUE)><#13>
!L<SENSORNUMBER>,<INDEX : 1..8>,W <ANALOG VALUE><#13>
Setting the altitude for calculating the barometric pressure:
!O<ALTITUDE(m)><#13>
Setting the factor for correct measurent of the supply voltage (VCC):
!PL,G0.000504
Reset of precipitation measurement:
!R<X><#13>
X is the full hour for precipitation reset if storage interval is > 0 (logger on)
!R<#13>
Sets precipitation to 0 if storage interval = 0 (logger off)
