jetStamp
792/792 MP
51
GB
1. Preparation and Set-up
1.1. Set-up
Only connect the device to the PC after the 790 PCset easy software has been installed
(see “Installing 790 PCset easy-Software”, page 56).
f
Connect
jetStamp
792 to the connection electric stamp
14
of the adapter
12
.
f
Connect mains unit to the connection voltage supply
13
of the adapter
12
.
f
Push mains unit into the socket.
The display
9
shows “INPUT - TIME 1”.
1.2. Setting time and date
f
See “Setting time and date”, page 64.
1.3. Insert cartridge
When using special ink (MP), observe the notes in the operating instructions.
CAUTION
Health risks if ink is swallowed.
f
Don’t swallow!
f
Keep cartridge out of the reach of children!
Insert cartridge
Fig.
A
+
C
+
E
f
Remove the
jetStamp
792 from the base station
4
.
f
Press [MODE] until [INKJET] appears in the display menu bar.
f
Press [INKJET].
The print carriage moves into a central position.
f
Push the locking rail
7
as far back as it will go.
f
Take the new cartridge
6
from its packaging and remove the protective film
18
from nozzles
16
or clip.
f
When using standard ink hold the small felt pad
17
that is provided, against the cartridge
nozzles
16
until some ink appears on the felt.
f
Holding the cartridge handle
10
, insert the cartridge
6
into the print carriage.
f
Pull the locking bar
7
forward again until it locks into place.
f
Press [INKJET].
The print carriage moves to the stamping position.