CUSTOMER SERVICE CENTRE 1300 780 250
Maintenance & Care
WARNINGS!
•
Always unplug unit before attempting to service.
•
Release pressure before disconnecting spray gun and spray wand.
•
Disconnect or unplug unit when not in use.
•
Never immerse pump.
Must be cleaned after every use:
•
After spraying, remove the suction hose from the container. Insert the wand tip into the
container and squeeze the spray gun trigger. Allow the unit to expel the unused material
back into the container. The wand and spray tip are left attached for this process to
provide a back pressure that will help expel 90% of the unused material out of the unit.
•
Remove unit from the spraying solution container, and circulate either soapand water,
diesel or other recommended cleaning solution through the unit until it comes out clean
and clear. NEVER USE XYLENE.
•
Drain all liquid from the pump. Do NOT allow liquid to freeze in the pump. Failure to do
so will result in damage to internal components of the pump.
Trouble−shooting
Fault
Action
Check the circuit breaker
Check for proper voltage (+/−10%) & good electrical
connections
Check pressure switch for proper operation
Check motor for an open or grounded circuit
Pump will not start
Check for a locked drive assembly
Check for loose screws at the switch or pump head
Switch diaphragm may be torn or pinched
Leaks from pump head or switch
Check pump diaphragm for tears or holes
