NOTES FOR CORRECT USAGE
•
We recommend the use of load-sensing or overload
protection devices on all lifts.
•
The risk assessment and method statement must
consider additional loading resulting from any “wet
lift” situations.
•
Ensure suitable winches and connection plates are
used for all applications
•
Due care and attention should be practiced when
transporting and storing the gantry to avoid damage.
•
Do not throw the gantry or its components down or
stack items on top of it. Always place properly on the
ground avoiding damage to the equipment.
•
Assemble only as instructed (ensure all bolts are
present and fitted correctly as per instructions)
.
•
We recommend that gloves should be worn when
using this equipment.
•
Set up the gantry at a safe distance from the hazard
and subsequently move the structure into place.
•
The beam must be horizontal prior to any lift and
A-frames vertical and parallel to each other.
•
Do not use the gantry if the trolley does not run freely
along the beam.
•
Attach hoist only to the lifting point on the trolley.
•
Avoid side pull. Lowering and lifting should only be
carried out when the load chain/lifeline form a
straight and vertical line between the load and lifting
attachment point on the trolley.
•
Do not allow load to swing.
•
When lifting keep the load low to the ground.
•
NEVER walk away from structure whilst still being
connected.
•
Only raise and lower loads when
CASTOR BRAKES
are
ENGAGED
.
•
When using the gantry as a fall arrest anchor the
required clearance of the fall arrest device should be
considered - refer to device’s Assembly & Operation
manual and consider the height adjustment on the
gantry.
•
Before the gantry is used consideration must be given
to the potential effects of the lifelines over sharp
edges, chemical reagents, electrical conductivity,
cutting, abrasion, climatic exposure and the effect of
offset forces as a result of pendulum falls.
•
The gantry is not to be moved under load except
when a Competent Person or authority approves
a risk assessment and a method statement for a
particular reason.
•
To ensure stability of the structure, the operating
span of the beam must be equal to or greater than
the distance between the castors on the A-Frame.
Warning
•
The equipment shall not be used outside its limitations,
or for any purpose other than that for which it is
intended.
•
When winching only one lifeline should be used with
each sheave and they should never cross paths with
each other.
•
Do not lift or transport loads while personnel are in
the danger zone.
•
Do not allow personnel to pass under a suspended
load.
•
When gantry is used with multiple persons attached
working procedures should dictate that individual
lifelines do not cross and become tangled.
•
It is NOT recommended to mix the use of the gantry
with personnel and goods lifting concurrently.
•
A suspended load must not be left unattended.
Tel: +44 (0)1291 620796 www.reidlifting.com
