USING THE VIDEO POLE CAMERA
REI
VPC/VPX
6
USING THE VIDEO POLE CAMERA
ASSEMBLING THE UNIT
1. Remove the main body of the Video Pole Camera, which includes the pole and
monitor, from the case.
2. Remove the camera from the case
3. Place the camera on the pole such that two connectors align. There is a tab in
the connector on the pole and a slot in the connector on the camera.
4. Push and rotate the locking ring, located on the camera’s connector.
5. Place a battery pack in the battery holder with the cable away from the pole and
towards the foam grip.
6. Plug the battery connector into the DC Power IN Jack.
OPERATING THE MONITOR
1. Turn the monitor on by pressing the Power Switch.
2. Remove the lens cap from the camera.
3. Adjust the color saturation, contrast and brightness to obtain a desired video
image.
4. The monitor may be tilted and rotated as needed to allow better viewing of the
video image.
5. If desired or in low light conditions the LED illumination can be turned on. To turn
the LED illumination on press the Illumination Switch. The illumination brightness
may be adjusted by the Illumination Brightness control.
ADJUSTING THE CAMERA
The camera may be manually tilted using the outer pins on the camera body. The
camera can be 90 degrees to -25 degrees.
Because the Video Pole Camera can be used in many different conditions the
camera may require focusing. Focusing is a manually adjustment. To focus the
camera, rotate the lens by grabbing the outer ring of the lens. Avoid touching the
clear part of the lens.
In addition to the lens that is shipped on the camera, other lenses are supplied. To
switch lenses, unscrew the lens on the camera. Then screw the new lens on the
camera. Take care to keep any dust or foreign objects out of the camera while the
lens is off. The camera should have a lens installed at all times, including during
non-use periods.
