OPERATION
15
Operating the Monitor
1.
Turn the monitor on by pressing the Power Switch on the keypad. The camera will briefly move
through its entire range of motion and then settle to its last position before the unit was
switched off.
2.
If necessary adjust the Brightness, Contrast, and Saturation of the monitor (see Menu Items,
page 11) to achieve the desired video image.
3.
The monitor may be tilted as needed to allow better viewing of the video image.
Removing the Monitor
The monitor on the Pole Camera is designed to be easily removed from the pole assembly. To remove
the monitor from the pole assembly:
1.
Locate the cable assembly from the pole that connects to the back of the monitor enclosure.
2.
Gently tug in a downward motion on the connector of this cable assembly to disconnect it from
the monitor.
3.
Locate the spring-loaded knobs at each side of the pole camera's keypad.
4.
Twist and pull on the knob. It will remain in an open position.
5.
Gently slide the monitor assembly away from the pole until it comes completely off of the hinge
that it rests on.
6.
To reconnect the monitor to the pole, reverse the process.
Adjusting the Monitor Position
The monitor can be manually rotated almost 360
. To rotate the monitor, with one hand holding the
monitor in place, grasp near the bottom of the pole with the other hand and begin twisting the pole.
The camera also features a motorized tilt function. To tilt the camera, press the Camera Tilt Up/Down
buttons (see pg. 9)
Adjust the Camera Illumination
The camera features LED lights to provide supplemental light in low to dark lighting conditions. The
color camera features White LED lighting. The Black and White Camera features IR LED lighting. To
adjust the camera illumination, press the LED Brightness Up/Down buttons (see page 9)
Summary of Contents for VPC 2.0
Page 3: ...2...
