REI 10.2" TFT LCD Flip-Down, User Manual

Page: 9 / 10

9
7
– TROUBLESHOOTING:
7.1 No power ON:

Verify if the power cord is connected to the monitor.

Make sure that power cord is getting 24Vdc. Verify if the system fuse or the monitor fuse is
blown.
7.2 No Image:

Verify the video inputs cables are connected correctly.

In most of the cases, there is a video signal distributor that receives the image from the DVD
(or other video source) and retransmits the image to the monitors. Verify the video
connections and make sure the power cord is getting 24Vdc.
8
– OPERATION SPECIFICATIONS:

The monitor has an automatic opening system, managed by the presence/absence of video
signal.

When the video source is connected, the monitor opens automatically and in the back of the
screen, two blinking amber LEDs are warning passengers that the monitor is opening. When
the opening cycle finishes, the LEDs remain ON standing out the monitor and getting the
passengers attention that are walking through the bus aisle preventing possible accidents.

When the video source is disconnected, the monitor closes automatically. During this cycle,
the LEDs blink and warn the passengers that the monitor is closing. When the monitor is
closed and locked, the LEDs turned OFF.

When the screen opening is obstructed, the monitor returns to its original state (Closed) and
the opening cycle is interrupted. In this case, disconnect the system power and reconnect it
again causing the monitor restarts the opening cycle again.

If the monitor is manually closed, the screen returns to an opening state when the lock is
released. If this happens four times, the monitor enters in Protection mode and stays in
standby. In this case, disconnect the system power and reconnect it again causing the
monitor restarts the opening/closing cycle again.

When the screen closing is obstructed, the monitor returns to its original state (Open). If this
happens four times in a row, the monitor enters in Protection mode and stays in standby. In
this case, disconnect the system power and reconnect it again causing the monitor restarts
the closing cycle again.