INSTALLATION
OVERVIEW
Installation
The REHAU room unit is designed as an electronic temperature con-
troller of warm water heating systems and serves to control electro-
thermal actuators or other electrical devices.
The maximum switching current indicated in the technical data
must be observed! REHAU cannot accept any liability for any form of
misuse.
The electrical installation must be carried out in accordance to the
current wiring regulations in force and must be in accordance with the
connection plan. Only approved certifi ed professionals may carry out
the installation. Further more the installation is always to be carried
out with the power supply disconnected.
Position the room unit such that it is not covered by curtains, pieces of
furniture or other objects. The control should not be installed close
to heat sources (i.e. lamps, fi replaces/chimneys, direct sunlight etc.)
and positioned away from draughts. Ensure that it is fi tted on a fl at,
solid surface that is non-conductive between 1.2-1.5m off the ground
fl oor. This allows the room temperature to be measured at the correct
height and results in more comfortable control.
Wall mounting
Before mounting the wall unit, take-off the housing cover from the
base plate.
1. Remove the screw on the underside
2. Open the housing by lifting the housing cover on the bottom edge
and then lifting it.
Now fi rmly mount the base plate on the wall or the fl ush-mounted
socket with the screws provided.
Ensure batteries are positioned in corrext polarity and are
secure in the base plate
Connection
Wire the room unit in accordance with the following connection plan:
REHAU Star 50 230 V version
Terminals
Temperature Setback
N
Neutral
L
230 V AC supply
Switching output (actuator, strip terminal)
Replace the cover in the reverse order to above.
Operation
The electronic REHAU Star 50 room unit, controls the temperature in
dry closed rooms with normal environment and a maximum relative
room humidity of 95% (non-condensing).
The desired room temperature can be set very easily with + or - to
increase or decrease temperature Set Point. The REHAU Star 50
ensures stable room control by maintaining the set point room tem-
perature.
The REHAU Star 50 becomes the master controller and sends the
set back signal to all other Star controllers connected to the common
wiring centre.
Cleaning
Never use anything other than a soft, dry cloth to clean the unit. Ne-
ver use any cleaning agents containing solvents or any sharp objects
to clean the unit!
Navigation
Set up data Star 50
Set up data for PROGRAMMABLE
Electronic Room Temperature
controller for underfl oor heating
and cooling.
REHAU STAR COMFORT CONTROLS
INSTALLER/USER SETUP - STAR 50
PROGRAMMABLE ROOM CONTROLLER, ART NO: 205576
1 – Access the Main Menu by
pressing the Menu Button
2 – Navigate through the menu
by pressing – for lower and + for
higher entries
3 – Enter the selccted topic by
pressing the select button or
leave to the previous menu without
any changes by pressing cancel
Change Display
The Change Display menu off ers
the Full Screen, selected screen
and basic screen view.
Change Profi le
In the change profi le menu you
can choose between family, single,
offi ce, name 1 and Name 2 profi le
Change Holiday
In the change holiday menu you
can make your holidays settings
and turn them On or Off
Program On/Off
In the program menu you can
choose between Program or
Manual operation
Key Lock
By pressing – and + button for
three seconds, a Key Lock can be
attached to protect the controller
from failure operation
Basic Operation
Manual Operation
By pressing the – or + buttons,
the manual operation mode will
be activated. Current programs
will be overwritten until the next
daytime starts.
