www.vintage-mobility.ch
32
Explanations to Figure 17
Speed
Adjustment Dial
The speed adjustment dial is located on the handlebar panel.
When the speed limit dial is set to MAX, the
GATSBY
will drive at
approximately 15 km/h.
When the speed limit dial is set to MIN, the
GATSBY
will drive at
approximately 3 km/h.
Do not change the speed limit dial setting while the
GATSBY
is
moving.
Note
: Set the speed limit dial to MIN:
Until you get used to driving your new
GATSBY
,
and
When driving the
GATSBY
inside a building or in a crowded area.
High
– Low
Speed mode
Switch
Set the maximum speed of the scooter to HIGH or LOW speed. Use
the LOW speed mode when driving in close and crowded areas.
Throttle Control
Lever
To drive:
Gently squeeze the throttle control lever (depending on whether you
want to drive forward or backward) until you reach the desired speed.
The speed is directly proportional to the deflection of the throttle
control lever.
Note:
You can squeeze one side of the throttle control lever towards you, or
you can push the other side away from you to achieve the same effect.
Throttle control selection can also be activated by fingers or thumb of
both hands, use whichever method is most comfortable for you.
To stop
:
Release the throttle control lever. The
GATSBY
will stop gradually.
Turning buttons
Hazard button
Before you turn, press the applicable indicator button. When a turn
indicator is activated, the applicable LED will flash.
To turn off the indicator, press the button again.
The Hazard button activates the hazard lights (front and rear blinkers).
To turn off the hazard lights, press the button again.
Buzzer button
Automatic
Freewheel
switch
To activate the buzzer, push the buzzer button.
Turn the key switch to ON position. To activate push button and hold. To
release the brake just leave the button. This function allowed moving
scooter manually.
! Do not press the automatic freewheel button while the
WARNING
GATSBY
is moving.
Button for
headlight and
rear lights
To turn ON the lights (headlight and rear lights), press the Lights button.
When the lights are on, the Light LED is lit.
To turn OFF the lights, press the button again.