3
This thermostat is intended for
indoor use only. It should be
mounted on an inner wall, about
150cm above the
fl
oor, located
where room temperature changes
can be felt thanks to freely
circulating air.
Do not install above a heat source
(a TV set, heater, fridge etc.) or to
places where it may be exposed
to direct sunshine, draught,
radiation from appliances, or to
wet environment.
Wiring of the thermostat
Installation:
• Pres the latch on the bottom side to release the rear
board.
• Position the rear board on the wall so that cables run
directly through the rectangular opening and are not
stuck under the board. Check that the arrow points
upwards (see Pic.). Mark the position of the 4
fi
holes.
• Insert dowels into the drilled holes, run the cables
through the rectangular opening and
fi
x the rear board
to the wall with 4 screws.
• Wire the cables to the terminal block on the rear board.
This may be done by quali
fi
ed staff only.
• Make sure the mode selector is in
OFF
position and batteries are removed from their compartment.
• Set the thermostat onto the two top latches on the rear board and slightly press the bottom latch to lock.
TP07 thermostat
heating
heating
Wiring of the thermostat for RT3E.
TP07 thermostat
