UltraGlow G36D Zero Clearance Direct Vent Gas Fireplace
5
INSTALLATION
CHECKLIST
1)
Locate appliance
a) Room location, page 6
b) Clearances to Combustibles, pages 6
-8.
c) Mantle Clearances, page 8
d) Framing & Finishing Requirements,
page
7
e) Venting Requirements, pages 10 - 17.
2)
Assemble Top Standoffs and Top Facing
Support and Side Nailing Strips, page 9.
(NOTE: must be done before installing unit
into fi replace.)
3)
Install vent, pages 20-22.
4)
Make gas and electrical connections. Test
the pilot. Must be as per diagram. Page
23.
5)
Install log set where indicated on page 25
- 27.
6)
Install Flush Door Front (Standard) and
optional Flush Gold Trim, page 28.
7)
Install Louvers page 28.
8)
Install optional Wall Switch, Remote Control,
or Wall Thermostat, page 29.
9)
Final
check.
Before leaving this unit with the customer, the
installer must ensure that the appliance is fi r-
ing correctly and
operation fully explained
to customer
.
INSTALLATION
IMPORTANT:
SAVE THESE
INSTRUCTIONS
The G36D-NG or G36D-LP Direct Vent Fireplace
must be installed in accordance with these in-
structions. Carefully read all the instructions in
this manual fi rst. Consult the "authority having
jurisdiction" to determine the need for a permit
prior to starting the installation. It is the respon-
sibility of the installer to ensure this fi replace
is installed in compliance with manufacturer's
instructions and all applicable codes.
BEFORE YOU START
Safe installation and operation of this appli-
ance requires common sense, however, we
are required by the Canadian Safety Standards
and ANSI Standards to make you aware of the
GENERAL SAFETY
INFORMATION
1)
The appliance installation must conform
with local codes or, in the absence of local
codes, with the current Canadian or National
Gas Codes, CAN1-B149 or ANSI Z223.1
Installation Codes.
2)
The appliance when installed, must be
electrically grounded in accordance with
local codes, or in the absence of local codes
with the current National Electrical Code,
ANSI/NFPA 70 or CSA C22.1 Canadian
Electrical Code.
3)
See general construction and assembly
instructions. The appliance and vent should
be enclosed.
4)
This appliance must be connected to the
specifi ed vent and termination cap to the
outside of the building envelope. Never vent
to another room or inside a building. Make
sure that the vent is fi tted as per Venting
instructions.
5)
Inspect the venting system annually for
blockage and any signs of deterioration.
6)
Venting terminals shall not be recessed into
a wall or siding.
7)
Any safety glass removed for servicing
must be replaced prior to operating the
appliance.
8)
To prevent injury, do not allow anyone who
is unfamiliar with the operation to use the
fi replace.
9)
Wear gloves and safety glasses for protec-
tion while doing required maintenance.
10)
Be aware of electrical wiring locations in
walls and ceilings when cutting holes for
termination.
11)
Under no circumstances should this ap-
pliance be modifi ed. Parts that have to be
removed for servicing should be replaced
prior to operating this appliance.
12)
Installation and any repairs to this appliance
should be done by a qualifi ed service per-
son. A professional service person should
be called to inspect this appliance annually.
Make it a practice to have all of your gas
appliances checked annually.
13)
Do not slam shut or strike the glass door.
14)
Under no circumstances should any solid
fuels (wood, paper, cardboard, coal, etc.)
be used in this appliance.
15)
The appliance area must be kept clear and
free of combustible materials, (gases and
other fl ammable vapours and liquids).
INSTALLATION AND REPAIR SHOULD
BE DONE BY A QUALIFIED SERVICE
PERSON. THE APPLIANCE SHOULD
BE INSPECTED BEFORE USE AND
AT LEAST ANNUALLY BY A PRO-
FESSIONAL SERVICE PERSON.
MORE FREQUENT CLEANING MAY
BE REQUIRED DUE TO EXCESSIVE
LINT FROM CARPETING, BEDDING
MATERIAL, ETC. IT IS IMPERATIVE
THAT CONTROL COMPARTMENTS,
BURNERS AND CIRCULATING AIR
PASSAGEWAYS OF THE APPLIANCE
BE KEPT CLEAN.
DUE TO HIGH TEMPERATURES, THE
APPLIANCE SHOULD BE LOCATED
OUT OF TRAFFIC AND AWAY FROM
FURNITURE AND DRAPERIES.
WARNING: FAILURE TO INSTALL THIS
APPLIANCE CORRECTLY WILL VOID
YOUR WARRANTY AND MAY CAUSE
A SERIOUS HOUSE FIRE.
CHILDREN AND ADULTS SHOULD
BE ALERTED TO THE HAZARDS OF
HIGH SURFACE TEMPERATURES, ES-
PECIALLY THE FIREPLACE GLASS,
AND SHOULD STAY AWAY TO AVOID
BURNS OR CLOTHING IGNITION.
YOUNG CHILDREN SHOULD BE
CAREFULLY SUPERVISED WHEN
THEY ARE IN THE SAME ROOM AS
THE APPLIANCE.
CLOTHING OR OTHER FLAMMABLE
MATERIAL SHOULD NOT BE PLACED
ON OR NEAR THE APPLI
ANCE.
Emissions from burning wood or gas could
contain chemicals known to the State of Cali-
fornia to cause cancer, birth defects or other
reproductive harm.
