Regency P33 Sunrise Gas Fireplace
Maximum:
4
0
ft.
(12.2m)
Minimum
9
’6”
(2.9m)
Minimum
8
’6”
(2.6m)
Max. 10’ (3m)(centerline to centerline)
Minimum 12” (305mm)
Maximum:
2
7
ft.
(8.2m)
0
2
4
6
40
8
10
12
14
16
18
20
22
24
26
28
30
V
ertical
Height
(Feet)
32
34
36
38
6
8
2
0
4
10
12
16
16
18
14
20
26
28
22
24
30
16
2
4
6
8
10
12
14
2
0
0
12
20
6
14
30” (762mm)
Minimum
Height
Requirement
26” (660mm) - Flex
- Rigid
4
8
10
18
16
V
ertical
Height
(Feet)
Horizontal (Feet)
8"(0.2m)
2’ (0.6m)
Venting Arrangements - Horizontal
Terminations
This lightly shaded area of the diagram shows allowable combinations of
vertical runs with horizontal terminations,
using one 45° and one 90° elbow
(two 45º
elbows equal one 90° elbow).
Note: Must use optional rigid pipe adapter (Part # 510-994) when using
Rigid Pipe.
•
Maintain clearances to combustibles.
•
Horizontal vent must be supported every 3 feet.
•
Firestops are required at each
fl
oor level and whenever passing through
a wall.
A vent guard may be required as per local codes,
refer to Exterior Vent
Termination Locations.
Note: FPI Direct Vent System (Flex) is only approved for horizontal
terminations.
P33 Sunrise Gas Fireplace
Venting Arrangements - Vertical
Terminations
Rigid Pipe System
(Propane & Natural Gas)
The P33 is approved for a maximum 40 ft. straight vertical, with
Rigid
Pipe
vent systems for Propane and Natural Gas.
The lightly shaded area,
6
8
2
0
4
10
0
2
4
6
40
8
10
12
14
16
18
20
22
24
26
28
30
32
34
36
38
12
, in the diagram shows allowable venting
con
fi
gurations with a maximum two 45° elbows.
The darker shaded area,
6
8
2
0
4
10
0
2
4
6
40
8
10
12
14
16
18
20
22
24
26
28
30
32
34
36
38
12
, in the diagram shows allowable venting
con
fi
gurations using one 45° and one 90° elbow.
•
Vent must be supported at offsets.
•
Horizontal sections must be supported every 3 feet.
•
Firestops are required at each floor level and whenever
passing through a wall.
•
Maintain clearances to combustible materials.
•
Minimum of 1’ pipe section between elbows.
Note: Must use optional rigid pipe adapter when using Rigid Pipe
(Part # 510-994).
Note: Height measured from the base of the unit.
Note: Height measured from the base of the unit.
