Regency Horizon™ HZ42STEPV Gas Fireplace
35
INSTALLATION
GTMF REMOTE INSTALLATION
DFBC
= digital fi replace burner control
1)
Remove the faceplate and glass door to access to DFBC &
battery pack tray.
2)
Lift DFBC and battery pack up and out.
3)
Remove the hi/lo knob from the valve head, if installed, by removing
2 screws as shown below.
4)
Install the stepper motor in the same location the hi/lo knob was
removed from - with 2 screws as shown below.
9)
Program Receiver and transmitter (refer to manual)
Note:
DO NOT USE 4 AA batteries on the control module; the DFBC is
now powered by the receiver batteries in the wall.
8)
Connect GTM motor wire from the stepper motor to the wire connector
from the receiver wire harness.
5)
Install 4 - AA batteries into the receiver, ensure correct polarity.
7)
Plug receiver wires into the back of the receiver and bundle wires
with the wire clip as shown below.
Wire Clip
6)
Remove the module tray on the right side of the unit to access the DFBC
