STEP 6:
Choose your desk orientation and
place the
30” Deep
Long Table Top(K), 24” Deep Long Table Top(M),
and
Short Table
Top(L)
on a clean flat surface with desired table finish face down so the sides of the three tops are flush on the long “connecting” side.
Connect an
End Leg
to one
Short Modesty(J)
with 2
Bolts(O)
and 2
Washers(N)
ensure the lip of the modesty is facing toward the
Short Top(M)
. Then Connect the opposite end of the
Short Modesty(J)
to 1
Corner Leg(G)
with 2
Bolts(O)
and 2
Washers(N)
as
shown below. Be sure there is no gap between the modesty and the top. If so, loosen
Bolts(O)
and adjust.
DO NOT ATTACH TO THE
TOPS.
Any problems or questions call Regency Office Furniture at 1-866-816-9822
STEP 4A:
Snap the
Interior Leg Cover(F)
into
Back Support(C)
and
Front Support(D)
using a rubber mallet.
NOTE:
Interior Leg Cover is installed on the side with the modesty holes.
STEP 4B:
Snap the
Exterior Leg Cover(E)
into
Back Support(C)
and
Front Support(D)
using a rubber mallet. The assembled legs
will now be referred to as the
End Legs.
C
D
Modesty Holes
F
E
D
C
NOTE : PRODUCT IS REVERSIBLE.
THE FOLLOWING STEP INCLUDES BOTH RIGHT AND LEFT ORIENTATIONS.
THE REMAINING STEPS ARE THE SAME NO MATTER THE ORIENTATION.
MUDS663042, MUDS663048, MUDS723042, MUDS723048 - INSTRUCTIONS
K
M
L
K
L
M
J
G
O/N
J
G
O/N
Right Bridge
Left Bridge
(N,O)
FLUSH
FLUSH
