18
Regency F1100/F3100 Freestanding Woodstove
INSTALLATION
Side View
Front View
Front View
4)
Install the third air tube into the holes on the
side channels. The notch goes on the right
hand side with the air holes facing forward
toward the door opening. If the tube will
not slide in easily, simply use a pair of vise
grips or pliers and tap it into place with a
hammer. A tighter fi t will ensure the tube
will not move when the unit is burning.
Note: When cleaning the chimney reverse
the above procedures, removing
the air tube and baffl e bricks and
then replace them when cleaning is
completed.
Large Stove F3100L
The unit arrives with the third air tube (from the
front) and the 2 baffl e bricks on the fl oor of the
fi rebox. The baffl e bricks are positioned fi rst and
then the air tubes are installed.
1)
Slide the left baffl e brick over the two rear
air tubes and then push it all the way to the
left side of the fi rebox.
Front View
2)
Tilt the fi rst Baffl e Brick down and then slide
the 2nd Baffl e Brick up and back. Reposition
both baffl e bricks fl at on the air tubes.
3) Important: push both baffl e bricks so
they are tight against the side walls.
Side View
BRICK FLUE BAFFLE &
SECONDARY AIR TUBE
INSTALLATION
The fl ue baffl e system located in the upper area
of the fi rebox is removable to make cleaning
your chimney system easier. The brick baffl es
must be installed prior to your fi rst fi re.
Smoke
spillage and draft problems may occur if the
baffl es are improperly positioned.
Check the
position of the brick baffl es on a regular basis as
they can be dislodged if too much fuel is forced
into the fi rebox.
The Large Stoves F3100L and S3100L are
shipped with one of the secondary air tubes
loose inside the fi rebox. It needs to be installed
after the brick baffl e are installed. Follow the
directions below.
Small Stove F1100S
1)
If the two air tubes are installed continue on
to Step 2), if not, follow the instructions below.
Install the air tube into the holes in the side
channels. The notch goes on the right hand
side with the air holes facing toward the door.
Slide the tube into the left hand side, as far
as possible and then bring it back into the
hole on the right hand side until it locks into
position. If the tube will not slide in easily
simply use a pair of vise grips or pliers and
tap it into place with a hammer. A tighter fi t
will ensure the tube will not move when the
unit is burning. Refer to the Mobile Home
Installation section, though there are only
two air tubes in the small units.
2)
Slide the left baffl e brick over the front air
tube and then slide it back over the rear air
tube.
3)
Tilt the left baffl e brick up on top of the side
channel and it will leave enough room to
position the right baffl e brick in the same
manner as Step 1 above. Then reposition
the left baffl e brick fl at on the air tube.
4) Important: push both baffl e bricks so
they are tight against the side walls.
Note: When getting the chimney cleaned,
remove the baffl e bricks for access
to the fl ue, then replace them when
cleaning is completed.
