Regency FG39-1 FireGenie Freestanding Gas Stove
19
INSTALLATION
918-578
12/20/06
4
PG121-1 / PG131-1 / FG39-1
12)
Stick the conversion label "This unit has
been converted to LPG" over top of the
serial number decal.
13)
Replace the yellow "NG" label with the red
"LPG" label.
14)
Carefully pull out the control box.
Note:
The control box is held in place by
velcro.
15)
Remove the control box cover by undoing
the 3 screws. Maneuver through antenna.
Control Box
Cover
Antenna
17)
Stick the conversion label "This unit has
been converted to LPG" on the control box
cover.
18)
Reverse steps 15, 14 & 11.
19)
Open the bottom door and remove the front
panel by undoing the 6 screws.
16)
Remove the jumper using a plier.
After carrying out all adjustments, block
the setting screws with paint, taking care
not to obstruct the breather orifi ce of the
pressure.
Put back the modulator plastic cap.
WARNING:
To ensure the correct opera-
tion of the modulator it is necessary that
the plastic cap (A) is returned to its original
location.
Cable
Electric
Modulator
21) Adjusting the Outlet Pressure
All the adjustments must be carried out in
the following order:
Remove the modulator plastic cap (A) using
needle nose pliers.
Maximum pressure:
Turn the unit ON to
its highest input rating. Screw in the nut (B)
to increase the outlet pressure and screw
it out to decrease it. Use a 10 mm wrench.
NOTE:
The outlet pressure must be set to
maximum 2.65 kPa.
20)
Turn on the gas supply and plug in the power
cord.
Installer Notice:
These instructions must be left
with the appliance.
22)
At the end of all setting and adjustment
operations, check electrical insulation and
gas leaks.
23)
Reverse step 19.
24)
Check operation of fan and fl ame control.
25)
Check for proper fl ame appearance and
glow on logs.
C
B
A
Minimum pressure:
Remove one of the
cables connected to the electric modulator.
Keeping the nut (B) blocked, screw in the
screw (C) to increase the pressure and screw
it out to decrease it. Use a screwdriver 6 x
1 blade.
NOTE:
The outlet pressure must be set to
minimum 0.74 kPa.
Jumper
Jumper Location
Summary of Contents for FG39LPG1-BRA
