Regency Bellavista™ B41XTE -1 Gas Fireplace
17
INSTALLATION
10)
From the inside of the
fi
rebox,
place the exhaust assembly into position
as shown in Diagram 1 and secure with 10 - 1/4" x 1/2" screws (Diagram
2). Ensure all screws are tight, but do not over tighten.
All 10 screws must be used.
Diagram 1
Diagram 2
12)
From the outside rear of the
fi
rebox,
install the intake cover plate with
4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not over tighten.
All 4 screws must be used.
13)
Set vent restrictor accordingly - see next page.
14) From inside the
fi
rebox,
re-install the baffl e plate from step 2.
11)
From the outside top of the
fi
rebox
, install the intake collar assembly.
Secure with 4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not
over tighten. All 4 screws must be used.
Intake Collar
Assembly
Exhaust
Assembly
8) From the outside top of the
fi
rebox -
completely remove the insulation
under the cover plate as shown and discard.
9) From the outside back of the
fi
rebox -
locate the insulation defl ector
and bend completely upwards fl at against the back of fi rebox.
IMPORTANT:
If the insulation defl ector is not bent fl at against the back of
the fi rebox this will block air intake which will affect the unit's performance.
View Front of Firebox
Insulation Defl ector
15) From inside the
fi
rebox
, reinstall the top heat defl ector by placing 2 screws.
Heat Defl ector
Diagram 2
16) From inside the
fi
rebox
, reinstall the baffl e plate by placing 4 screws -
replace top front screw fi rst. Leave loose - until rear screws installed.
See Diagram 3.
Baffl e Plate
Diagram 3
Note
: Reuse existing screw holes - do not make new holes. Tighten screws.
