Regal-Seton APPROX 4, User Manual

Page: 7 / 10

- 7 -
14.1 – Std (Standard) – Choose standard chase
In this submenu operators can choose a chase to be run or to be a stand-by chase from the
preset or edited ones available. The marks of the preset programs are
1 - 9 , the marks of the
logically editable programs are A ; b ; C , the mark of the level-memory editable program is SP
(special).
14.2 – SPEE (Speed) – Set running speed
The running speed of a chase is determined by the cross-time between the steps and the hold-
time of the scene. Entering the submenu two value, consist of two digits each, can be seen on
the display. The first value determines the cross-time, the second value determines the hold-
time in tenths of seconds. The value where the decimal point is lit can be set by the use of
UP/DOWN. To change between the values to be set use ENTER (short).
Approx 4 immediately shows the speed on its outputs during the setting procedure. To
confirm the values set press and hold down ENTER.
14.3 – nnod (Mode) – Choose operating mode
The operating modes of a chase can be the following:
- oFF : the standard chase is off
- Auto : the running speed of the chase is determined by the settings set in the
. menu Speed (14.2)
- Soun (sound): music sync mode, in this case the signal is provided by the built-in
microphone according to the cross and hold times set in the menu Speed (14.2)
14.4 – Edit (Edit) – Edit a chase
Entering the submenu choose the chase to be edited. Each chase can made up of a maximum
of 30 steps. Entering to edit
A , b or C chase a label LEUE (level) appears on the display for a
second, then the maximum output levels dedicated to the 4 channels can be seen. Here it is
possible to limit the output level further in proportion to the operating range set in the menu
Limit (4). The values dedicated to the channels can be set from
0 to F (full) at the scale of
10% by the use of UP/DOWN. To change between the channels press ENTER (short). If the
maximum output levels of the channels have been set press and hold down ENTER to access
the edit steps. The serial number of the step to be edited appears on the display for a second
(e.g.
St 1 ).
To facilitate quick editing, the serial numbers of the buttons are the same as the
channels’ and pressing the buttons, channels can be switched on or off.
Setting the first scene press and hold down UP to step to the next scene. To step back
to the previous scene press and hold DOWN.
To confirm editing press and hold ENTER.
Attention!!! The serial number of the step you quit by ENTER determines the length of the
chase. The steps above that number are stored, but will not run.
Pressing and holding down ESC editing can be quit without storage.
The editing of the special chase is the same as the maximal level’s setting of the logically
editable chase. Entering the special chase the serial number of the step to be set appears on the
display for a second, then the levels of the channels dedicated to the scene can be set from
0
to F . Skipping between scenes (up and down), finishing or leaving chase editing is the same
as in the logically editable chase.