INPUT SELECTION
Using the front display
1. Press the INPUT button on the front panel.
Press the INPUT button to select which input mode you require according to
your setup. The input sequence is as following:
Optical 1
Æ
Optical 2
Æ
Coaxial 1
Æ
Coaxial 2
Æ
Aux
Æ
87.50 (FM Radio)
a. If ‘OP1’ is shown on the LCD this indicates that the Optical 1 input is
selected.
b. Press the - buttons on the front panel or remote control to
adjust the volume level between 00
Æ
63.
c. To select the next input source, press the INPUT button until it is shown
on the LCD.
Using the remote control
a. Press the OPTICAL 1 / 2 buttons, to select the Optical 1 or 2 inputs, ‘OP1’
or ‘OP2’ will appear on the LCD.
b. Press the COAXIAL 1 / 2 buttons, to select the Coaxial 1 or 2 inputs,
‘CO1’ or ‘CO2’ will appear on the LCD.
c. Press the AUX button to select the Aux input. ‘AU’ will appear on the LCD.
d. Press the ‘FM’ button to select the FM Tuner. The selected frequency will
appear on the LCD.
SPEAKER VOLUME LEVEL SELECTION
The speaker volume levels can be individually controlled.
e.g..
1. Press the ‘’ or ‘CENTER-’ buttons on the remote
control to adjust the volume level of the center speaker, the
speaker volume level will appear on the LCD.
2. The same procedure applies for the other speakers
(SW, FR, FL, RR, RL).
